All commands sent from the computer to the receiver consist of five-byte blocks, with up to 200 ms between each byte. CAT Data Protocol Serial data is passed via the CAT jack on the rear panel of the radio at 4800, 9600, or bits/sec. Connect the a (D-SUB 9-pin) RS-232C cross cable (not supplied) between the CAT jack on the rear panels of the radio to your PC. (5) Confirm that the cursor is on the WRITE menu option, then press the key. (4) Confirm that the cursor is on the END menu option, then press the key. (3) Rotate the DIAL knob to set the cursor to the desired rate (4800/9600/57600 bps), then press the key. (2) Rotate the DIAL knob to set the cursor to the CAT RATE menu option, then press the key. Set baud rate to such as 4,800/9,600/57,600 bps, per the following steps: (1) Press the key momentarily, then press the key. 1 VR-5000 Communication Receiver CAT Information DATA Rate setting (This function cannot control form CAT) 1.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |